Roland RS-70 - Manual (Page 111)

111
Adding effects
Effects
45: AUTO PAN
The Auto Pan effect cyclically modulates the stereo location of the
sound.
fig.MFX-45
46:TUMBLING DLY (Tumbling Delay)
This is a delay that first produces “tumbling” delayed repeats, and
then echoes the original sound.
It is most effective when applied to single notes of a “one-shot”
sound.
fig.MFX-46
47: FBK RIPPER (Feedback Ripper)
This effect repeatedly cuts the sound, and outputs a delayed sound
for the cut portion. You can create new phrases by applying this to a
drum phrase or other phrase.
fig.MFX-47
Parameter Value Description
Mod Wave TRI, SQR, SIN,
SAW1/ 2 TRI: The sound will be modulat-
ed like a triangle wave.
SQR: The sound will be modu-
lated like a square wave.
SIN: The sound will be modulat-
ed like a sine wave.
SAW1/2: The sound will be
modulated like a sawtooth
wave. The teeth in SAW1 and
SAW2 point at opposite direc-
tions.
Rate # 0.05–10.00 [Hz],
note *2 Adjusts the frequency (speed) of
the change.
Depth # 0–127 Sets the depth to which the ef-
fect is applied.
Reset OFF, ON This setting determines whether
the period for the pattern is reset
(ON), or not (OFF) when sounds
are played.
While the sequencer is playing,
the period for the pattern is not
reset even if you set this ON.
Low Gain -15– +15 [dB] Adjusts the gain of the low fre-
quency.
High Gain -15– +15 [dB] Adjusts the gain of the high fre-
quency.
Level 0–127 Adjusts the output level.
L in
R in
L out
R out
Auto Pan
2-Band EQ
2-Band EQ
Auto Pan
SAW1 SAW2
RESET
LEVEL
L in
R in
L out
R out
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
2-Band
EQ
Feedback
Tumbling Delay
Parameter Value Description
Type TYPE1–TYPE6 Selects one of the six available
types for the number of delay
sounds heard in time “A” in the
diagram below.
Pre Delay 0–500 [ms] Adjusts time “A” in the diagram
below.
Delay Time 0–345 [ms] Adjusts time “B” in the diagram
below.
HF Damp 200–8000 [Hz],
BYPASS Adjusts the frequency above
which sound fed back to the ef-
fect will be cut.
If you do not want to cut the
high frequencies of the feed-
back, set this parameter to BY-
PASS.
Feedback # -98– +98 [%] Adjusts the proportion (%) of
the delay sound that is fed back
into the effect.
Negative (-) settings will invert
the phase.
Balance # D100:0W–
D0:100W Adjusts the volume balance be-
tween the direct sound and the
delay sound.
With a setting of D100:0W only
the direct sound will be output,
and with a setting of D0:100W
only the delay sound will be out-
put.
Level 0–127 Adjusts the output level.
Level
original tone
A B B
R in R out
L in L out
Feedback
Feedback
2-Band
EQ
2-Band
EQ
Delay
Delay
Ripper
Ripper
RS-70_e3.book 111 ページ ２００３年６月１８日 水曜日 午後１２時５４分