Roland RS-70 - Manual (Page 127)

127
Settings common to all modes (System Function)
System Function
Settings related to MIDI and USB
(MIDI&USB)
Patch Rx Ch (Patch Receive Channel)
Specifies the receive channel of MIDI messages in Patch mode.
VALUE: 1–16
Patch Tx Ch (Patch Transmit Channel)
Specifies the transmit channel of MIDI messages in Patch mode. If
you do not want to transmit MIDI messages to external MIDI
devices, turn this parameter “OFF.” If you want the transmit channel
to always match the Patch Receive Channel, set this parameter to
“RxCh.”
VALUE: 1–16, RxCh, OFF
Ptn/Perf Ctrl Ch (Pattern Control Channel)
Pattern Ctrl Ch selects the MIDI receive channel used during
switching of patterns when MIDI messages (Program Change/Bank
Select) are sent from an external MIDI device. Set this to “OFF” if
patterns are not to be switched from an external MIDI device.
Pattern control data will not be received while the Quick Sequencer
is playing.
VALUE: 1–16, OFF
If only a program change is received, and if the Ptn/Perf Ctrl Ch
parameter setting coincides with the MIDI receive channel of a
part, priority will be given to switching the pattern.
If this is set to 1–16, the RS-70 will transmit MIDI messages
(program change/bank select) on that channel when the pattern
is switched.
Rx Prog Chg (Receive Program Change Switch)
Specifies whether Program Change messages will be received (ON)
or not (OFF).
VALUE: OFF, ON
Rx Bank Sel (Receive Bank Select Switch)
Specifies whether Bank Select messages will be received (ON) or not
(OFF).
VALUE: OFF, ON
Rx Sys Exc (Receive System Exclusive Switch)
Specifies whether System Exclusive messages will be received (ON)
or not (OFF).
VALUE: OFF, ON
Tx Prog Chg (Transmit Program Change
Switch)
Specifies whether Program Change messages will be transmitted
(ON) or not (OFF).
VALUE: OFF, ON
Tx Bank Sel (Transmit Bank Select Switch)
Specifies whether Bank Select messages will be transmitted (ON) or
not (OFF).
VALUE: OFF, ON
Tx Edit Data (Transmit Edit Data Switch)
Specify whether changes you make in the settings of a patch or
pattern will be transmitted as system exclusive messages (ON), or
will not be transmitted (OFF).
VALUE: OFF, ON
Tx Active Sens (Transmit Active Sensing
Switch)
Specifies whether Active Sensing messages will be transmitted (ON)
or not (OFF).
VALUE: OFF, ON
Device ID (Device ID Number)
When you want to transmit or receive System Exclusive messages,
set this parameter to match the Device ID number of the other MIDI
device.
VALUE: 17–32
Soft Thru (Soft Through Switch)
The Thru function re-transmits all messages received at the MIDI IN
connector to the MIDI OUT connector without modifying them in
any way.
VALUE: OFF, ON
MIDI-USB Thru
If you leave this “OFF,” MIDI messages arriving at the MIDI IN and
the USB connectors are all sent to the sound generator. If you set this
“ON,” MIDI messages arriving at the MIDI IN connector are output
as is from the USB connector, while the MIDI messages that arrive at
the USB connector are output through the MIDI OUT connector.
VALUE: OFF, ON
The modified settings will become effective after you save the
SYSTEM function (p. 124) and switch the power to the RS-70 off,
then on again.
RS-70_e3.book 127 ページ ２００３年６月１８日 水曜日 午後１２時５４分