Roland RS-70 - Manual (Page 66)

66
Using the sequencer to create patterns (Pattern mode)
The Quick Sequencer (QUICK SEQ) built into the RS-70 makes it
easy to loop-record over preset rhythms or your own original
rhythms to quickly create
patterns (performance data several
measures in length). If you’re not satisfied with the recorded content,
you can erase it at the touch of a button and try again until you are
happy with the results, in this way building up an original song.
By using preset patterns 001–128 as well, you can create a
maximum of 256 patterns. (This will depend on the amount of
performance data within each pattern.) As necessary, you can
create patterns that are as long as 998 measures.
You will use Pattern mode to create and play back patterns. In
Song mode you can arrange the created patterns in the desired
order to create an entire song (p. 114).
Playing patterns
In Pattern mode you can simultaneously play up to sixteen parts,
each with their own sound (Patch or Rhythm Set). For example, with
parts configured as shown below, drums, piano, guitar, and bass
will play simultaneously, giving you a band-like ensemble.
EXAMPLE
0 RHYTHM & SFX part: rhythm set
1 PIANO part: acoustic piano
3 GUITAR part: electric guitar
9 BASS part: fretless bass
By switching patterns and adding or removing parts
(instruments) while playback continues, you can perform dance
music in a way similar to when using Roland’s “Groovebox”
series.
Basic playback operation
Use the following buttons to control the playback.
fig.r06-01.e
Selecting a pattern to play back
1. Press [PATTERN] so it is lit and you are in Pattern mode.
The name of the currently selected pattern is displayed.
Make sure that both [PART SELECT] and [TRACK MUTE] are
unlit.
fig.r06-02_40
2. Select the pattern number that you want to play.
Select the pattern number from 001 to 256.
In addition to rhythms, 001–009 also contain performances
already recorded on each part. When first trying out playback
methods, you may want to start by selecting these sample
patterns.
3. Press [ ] to play the pattern.
Press [ ] to stop play.
Selecting pattern numbers
Using VALUE [-]/[+]
Pressing VALUE [-]/[+] will select the pattern that precedes or
follows the currently selected pattern.
You do not need to press [ENTER] after making your selection. The
number you select will take effect immediately, and the pattern will
be selected.
Using the direct access buttons
• When not using the [NUMERIC] function
Use the [0]–[9] buttons to input a number.
The two upper digits will remain fixed, and only the lower digit
will change. This is a convenient way to step through the
numbers in succession.
You do not need to press [ENTER] after making your selection.
The number you select will take effect immediately, and the
pattern will be selected.
• When using the [NUMERIC] function
1. Press [NUMERIC] so it is lit.
2. Use the [0]–[9] buttons to input a three-digit number.
The indication will blink.
3. If you want to finalize the value, press [ENTER].
The value will be finalized, and [NUMERIC] will go out.
If you decide to cancel, press [EXIT].
Switching patterns during playback
If you switch patterns while a pattern is playing, the newly selected
pattern will begin playing after the currently playing pattern ends.
You can also perform a song by connecting patterns in this way.
1. While a pattern is playing, select the pattern that you want to
play next.
Returns to
the previous
measure.
Used for
recording
Advances to the
next measure.
Plays a song. Stops
playback.
Press these simultaneously to move
to the beginning of the pattern.
RS-70_e3.book 66 ページ ２００３年６月１８日 水曜日 午後１２時５４分