Restoring the factory settings (factory reset), 62 creating a patch (patch mode) – Roland RS-70 User Manual
Page 62
62
Creating a patch (Patch mode)
Transmitting patch/rhythm settings
from the MIDI OUT connector
(XFER to MIDI)
You can transmit the settings of any patch from the MIDI OUT
connector. This function can be used to save patch settings on an
external sequencer.
1.
Press [PATCH] so it lights and you are in Patch mode.
Select the patch or the rhythm set you want to output.
2.
Press [UTILITY].
3.
Use PAGE/CURSOR [
]/[
] to select “4:XFER to MIDI.”
4.
Press [ENTER].
5.
Use VALUE [-]/[+] to select “CURRENT PATCH” or “USER
PATCHES.”
If you selected “CURRENT PATCH,” proceed to step 8.
6.
Press PAGE/CURSOR [
] to specify the first number of the
range of user patch numbers that you want to transmit.
fig.r03-24_40
7.
Press PAGE/CURSOR [
] to specify the last number of the
range of user patch numbers that you want to transmit.
fig.r03-25_40
8.
Press [ENTER].
The selected patch settings will be transmitted from the MIDI
OUT connector.
After the data has been transmitted, the display will indicate
“COMPLETED.” This ends the procedure.
Restoring the factory settings
(FACTORY RESET)
You can also perform the FACTORY RESET operation from Patch
Utility.
For more about FACTORY RESET, refer to
“Reset to default
factory settings (Factory Reset)”
(p. 20).
RS-70_e3.book 62 ページ ２００３年６月１８日 水曜日 午後１２時５４分