Roland RS-70 - Manual (Page 30)

30
Applying various effects to the sound
Changing the tone with the knobs (Patch Modify)
Using the five panel knobs, you can change the tone in real time.
On the RS-70, each patch consists of two tones; the
upper tone and the lower tone
(p. 50). The way that the tones are sounded (Single/Split/Dual) is saved in each
patch, and you can change this using [KEY MODE] (p. 55).
■
Selecting the tone that you want to modify
(DESTINATION TONE)
Use the [DESTINATION TONE] button to specify whether you will modify the
upper or the lower tone.
fig.q05-01
• UPPER lit: Only the upper tone will be modified
• LOWER lit: Only the lower tone will be modified
• Both lit: Both the upper and lower tones will be modified
■
Adjusting the volume balance of the two tones
You can use a knob to control the volume balance of the upper tone and lower tone.
fig.q05-02
1. Press the patch modify select button to make the BALANCE/LFO indicator
light.
2. Turn the [BALANCE] knob.
Turning this to the right increases the volume of the upper tone, while turning it to
the left increases that of the lower tone.
Patch Modify applies +/-
adjustments relative to the
settings of the original tone.
Depending on the tone you
select, this may not always
produce a noticeable
change in the sound.
For a rhythm set, Patch
Modify applies to the set as
a whole.
1 2
You cannot change the
volume balance for rhythm
sets.
RS-70_e3.book 30 ページ ２００３年６月１８日 水曜日 午後１２時５４分