Roland RS-70 - Manual (Page 18)

18
Getting ready
3. Connect the RS-70 and the external device as shown in the figure.
Use audio cables to connect audio equipment, such as an amp or speakers. If you are
using headphones, plug them into the PHONES jack. Connect pedal switches or
expression pedals as necessary.
Turning on/off the power
Turning on the power
1. Before turning on the RS-70’s power, check the following:
• Are all devices connected properly?
• Are the volume controls of the RS-70 and any other connected equipment
turned to the minimum position?
• Is the AC adapter correctly connected to the RS-70?
2. Press the power switch on the rear panel of the RS-70 to turn on the power.
fig.q01-02
3. Turn on the power of the connected audio devices.
4. Play the RS-70’s keyboard and gradually raise the volume controls of the
RS-70, or the connected audio equipment to an appropriate volume level.
fig.q01-03
If you want to know how to make the connections with another external device, refer
to:
Using the RS-70 to play an external MIDI sound module
(p. 130)
Playing the RS-70’s sound generator from an external MIDI device (p. 131)
Recording to an external sequencer (p. 133)
Once the connections have
been completed (p. 17),
turn on power to your
various devices in the order
specified. By turning on
devices in the wrong order,
you risk causing
malfunction and/or
damage to speakers and
other devices.
Turn up the RS-70’s
volume level carefully.
Excessive volume can
damage connected audio
devices, your hearing, or
annoy your neighbors.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
RS-70_e3.book 18 ページ ２００３年６月１８日 水曜日 午後１２時５４分