Runco SIGNATURE CINEMA SC-50D - Manual (Page 22)

Controls and Functions
6 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
PRE
L
IMINAR
Y
1. RIGHT (INTAKE) SIDE PANEL
The right side panel is perforated to allow cool air to enter the projector.
2. LEFT (EXHAUST) SIDE PANEL
The left side panel is perforated to allow warm air to exit the projector. Removing this
panel provides access to the lamp.
3. INPUT PANEL COVER
Removing this panel provides access to the projector input panel. For more
information, refer to SC-50d/SC-60d Input Panel on page 6.
4. REAR EXHAUST VENT
Warm air exits the projector through this vent. Ensure that it is not obstructed in any
way.
5. ADJUSTABLE FEET (4)
Located on the underside of the projector are four adjustable feet. Raise or lower
these feet when positioning the projector to ensure it is level on all sides so the
displayed image will appear rectangular without any keystone.
6. PROJECTION LENS
2.2
SC-50d/SC-60d Input
Panel Figure 2-2 shows the SC-50d/SC-60d rear input panel.
Figure 2-2. SC-50d/SC-60d Input Panel
PWR
1 - Dual Link DVI-I 2 - VGA Signal Digital
Analog
2 - VGA Signal 2 - VGA Signal
2 - VGA Signal
RS232 IN
1 3 2 4
5
6
7