Runco SIGNATURE CINEMA SC-50D - Manual (Page 32)

Installation
16 Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
PRE
L
IMINAR
Y
Notes on Remote Control
Operation
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the DHD Controller.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the DHD Controller, and repeat the operation.
3.2
Quick Setup Table 3-1 gives a quick overview of the SC-50d/SC-60d installation process. The sections
following this one provide detailed instructions.
➤
Table 3-1. Installation Overview
Step Procedure
For Details, Refer
to page...
1 Choose a location for the projector 17
2 Install primary projection lens 25
3 Install CineWide with AutoScope lens motor (optional) 26, 38
4 Mount the projector 27
5 Connect the DHD Controller to the projector 29
6 Connect signal sources to the DHD Controller 31
7
Connect other external equipment to DHD Controller (optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (AutoScope lens motor,
retractable screens or screen masking etc.)
• External IR repeater
• Network hub, router or gateway (Ethernet)
36
8 Apply power to the projector 40, 41
9
Adjust primary lens: projected image size (zoom), position (shift)
and focus 19, 41
10
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation 42
11 Use Image Alignment controls to fine-tune image geometry 43
12 Install CineWide anamorphic lens (optional) 45
13
Adjust CineWide anamorphic lens: position, pitch (angle),
geometry and focus 47
14
DHD Controller input calibration: adjust the following for each
DHD Controller input and display mode (resolution/frame
rate); save settings when finished:
• Aspect ratio
• Color level
• Brightness • Tint
• Contrast • Input position
• Color temperature and white balance
53 through 68