Pre l iminar y – Runco SIGNATURE CINEMA SC-50D User Manual
Page 26
10
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
PRE
L
IMINAR
Y
4.
RS-232 (To Accessory Box)
A male, 9-pin D-sub connector for interfacing with external equipment. (For future
use.)
5.
Display Control
Connect this to the RS-232 input on the SC-50d/SC-60d projector.
6.
IR
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is a
3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
7.
POWER INPUT (100 to 240 VAC)
Connect the DHD Controller to power here.
8.
HD1 / HD2 (5 x Analog BNCs)
Two inputs (five BNCs per input) for connecting standard-definition (SD = 480i/576i),
enhanced-definition (ED = 480p/576p) or high-definition (HD = 720p/1080i/1080p)
component video sources, or RGBHV sources such as personal computers.
9.
Component / SCART (3 x RCA connectors)
SD/HD input for connecting SDTV, EDTV or HDTV component video sources. Also
provides RGB input for SCART RGBS sources.
10. Video 1 / Video 2 / Video 3
Standard, composite video inputs for connecting a VCR, camcorder or other
composite video source. The Video 1 input also provides composite sync input for
SCART RGBS sources.
11. HDMI 1 / HDMI 2 / HDMI 3 / HDMI 4 (Digital)
HDCP-compliant digital video inputs for connecting an HDMI or DVI source.
12. Ethernet
A female RJ-45 connector for wired network communications.
13. HDMI Out (Audio Only)
Connect this output to an audio control system to pass through HDMI audio.
14. HDMI Out (To Display)
Connect this to the DHD Input on the SC-50d/SC-60d (see Figure 2-2).
15. RS-232 (PC / Control)
A female, 9-pin D-sub connector for interfacing with a PC or automation/control
system.
The DHD Controller does not transmit HDMI CEC control
messages from the “HDMI Audio Out” connector.
Note