Focus, Verify proper image alignment with anamorphic lens, 13 working with the lamp – Runco SIGNATURE CINEMA SC-50D User Manual
Page 66: Working with the lamp, Pre l iminar y
50
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
PRE
L
IMINAR
Y
Focus: Finally, rotate the Focus Ring on the anamorphic
lens to fine-tune the optical focus.
Verify Proper Image
Alignment with
Anamorphic Lens
After you have installed the anamorphic lens, ensure that the 2.35:1 image corners and
edges are aligned with the screen with no geometric distortion. Use the Image Alignment
controls to make any necessary adjustments (refer to Adjusting the Image Geometry
on page 43).
3.13
Working With the
Lamp
At this point you may want to check and adjust the following settings to optimize lamp
performance:
• Choose a lamp mode for regulating power and light output.
• Change the optical aperture size.
To access them, choose Calibration from the Main Menu and enter the Calibration menu
passcode. Then, choose Display Color -> Lamp (refer to Lamp on page 66) or Display
Color -> RVR (refer to RVR on page 68).
F
O
C
U
S
➤