Runco SIGNATURE CINEMA SC-50D - Manual (Page 61)

Installation
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual 45
PRE
L
IMINAR
Y
3.12
Installing and
Adjusting the
CineWide Anamorphic
Lens If you are installing an SC-50d/CineWide with AutoScope or SC-60d/CineWide with
AutoScope, proceed as follows to install and adjust the secondary anamorphic lens.
The SC-50d/SC-60d Anamorphic lens mount kit consists of everything shown in Figure
3-23. Some components shipped with your projector may differ slightly from what is
shown in these instructions. If any items are missing or damaged, please contact your
Runco dealer or Runco Customer Service at (800) 23-RUNCO.
Figure 3-23. Anamorphic Lens Mounting Assembly - Exploded View
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Note
2
3
4
6
7
8
5
1
9
Pitch Adjustment Yoke for Lens
Height/Y Adjustment
T-Screw and Washer
(2x)
T-Screw and
Washer (2x)
Pitch Adjustment
Anamorphic Lens
Holder
1/4-20 Hex Bolt (2x)
and Washer (2x)
AutoScope Carriage Plate
Yaw/X Adjustment
Lever (2x)
Lens Adapter Ring and
Mounting Screws (3x)
Pitch Adjustment
T-Nut (2x)
10 Anamorphic Lens
Set Screw