Sleep timer, Pre l iminar y – Runco SIGNATURE CINEMA SC-50D User Manual
Page 79
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
63
PRE
L
IMINAR
Y
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Brightness
• Contrast
• Color saturation
• Tint
• Sharpness
• Gamma
• Lamp Settings
• Color temperature and white balance
To select a memory preset, press
or
to highlight it and press ENTER.
To save the settings for the current input and display mode to the Custom 1 or Custom 2
memory preset, select it, press
or
to highlight Save and press ENTER.
To reset the Custom 1 or Custom 2 memory preset to its factory-default state, select it,
press
or
to highlight Reset and press ENTER.
Select Sleep Timer from the Main Menu to turn off the SC-50d/SC-60d after a specified
interval. Press
or
to select Off, 30 Minutes, 60 Minutes, 90 Minutes, 2 Hours or
4 Hours. Then, press ENTER.
To save the settings for the current input and display mode to the
ISF Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 68).
Note
Î
Off
30 Minutes
60 Minutes
90 Minutes
2 Hours
4 Hours