24. attaching the anamorphic lens to the lens ring, Pre l iminar y – Runco SIGNATURE CINEMA SC-50D User Manual
Page 62
46
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
PRE
L
IMINAR
Y
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate
1.
Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Anamorphic Lens Holder (item #5).
2.
Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate (item #7).
Position the bracket so that the long slot at the bottom of the lens holder is
perpendicular to the corresponding slots on the plate.
3.
Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers
(item #6) and Yaw/X Adjustment Levers that you removed in Step 1.
4.
Use the Lens Mounting Screws to attach the Lens Adapter Ring (item #1) to the Pitch
Adjustment Yoke (item #2); see Figure 3-24. (Use the round, threaded holes on the
yoke.)
5.
Use the Height/Y Adjustment T-Screws/Washers (item #3), Pitch Adjustment
T-Screws/Washers (item #4) and T-Nuts (item #9) to attach the Pitch Adjustment
Yoke and Lens Adapter Ring to the Anamorphic Lens Holder. The Yoke should be
as close to the primary lens as possible.
6.
Attach the lens to the Lens Adapter Ring by threading it clockwise.
Figure 3-24. Attaching the Anamorphic Lens to the Lens Ring
➤
Lens threads into ring
FO
CU
S