Roland CD-2e - Manual (Page 43)

Recording an Electronic Instrument (continued)
43
Advanced Uses
Recording
Listening
Deleting
Creating a CD
Editing an SD
Appendices
Convenient
Functions
Information
/
Display
Checkin
g
/
Preparations
6
Press the [ (Record)] button to enter recording-standby mode.
fig.rec-intmic04-e.eps
7
Press the [ (Play)] button to begin recording.
Start your performance.
fig.rec-intmic05-e.eps
8
Press the [ (Stop)] button to stop recording.
fig.rec-intmic06-e.eps
The recorded song will be added to the end of the SD memory card or CD-R/RW disc.
If you want to listen to the song you recorded, press the [
(Play)] button
immediately after you stop recording.
Blinking
Remote control
Lit
Remote control
Remote control
● Sound will not be produced from the speakers while in recording-standby mode or while
recording. If you want to listen to the sound that’s being recorded, you’ll need to use
headphones. (Refer to Step 4 on Page 36.)
● When turning the [LINE] knob, you may hear a faint noise when the input level changes,
but this is not a malfunction.
● If you’ve finished recording a CD-R/RW disc and would like to play that disc on another
CD player, you’ll need to execute the “Finalize” operation. You can finalize the CD-R/RW
disc when ejecting it. For details, refer to “Making a CD-R/RW Disc for Playback on
Another CD Player (Finalize)” (Page 83).
● If you want to record your performance on an
electronic piano together with your voice, make
connections as shown in this illustration so that
the sound from the mic will also be output from
the speakers of the electronic piano.
With this setup, set LINE OUT Select to “MIC” to
prevent a feedback loop from occurring
between the CD-2e and the electronic piano.
For details, refer to “Selecting the Audio Source
that’s Sent from the LINE OUT Jack” (Page 109).
OUTPUT
Mic
CD-2e
LINE IN
EXT MIC (L/MONO)
LINE OUT
Electronic
piano
INPUT
Important
CD-2e_e.book 43 ページ ２００７年１０月２４日 水曜日 午前１１時１６分