Omega Speaker Systems High Speed Load Cell Interface Card LCIC-WIM-BEN - Manual (Page 17)

16
Step 5 – Save or Quit
This is the final step – here you decide whether to confirm the pseudo
calibration, or leave it out. Before you decide, you may watch the current
readings examining whether they are satisfactory.
• In case you do want to confirm the new (pseudo) calibration
(overwriting the previous calibration), press the ‘Save to
Board’ button and answer ‘Yes’ to the following question
that pops up:
• Otherwise – that is, you want to stay with the previous
calibration leaving out the ‘pseudo calibration’ – click ‘Exit’
and answer ‘Yes’ to the following question that pops up:
Please note that after saving the calibration to the board you still may
remain in the utility, which will show now
board’s response after the
calibration, which is now ‘real’ and not ‘pseudo’ any more.