Omega Speaker Systems High Speed Load Cell Interface Card LCIC-WIM-BEN - Manual (Page 53)

52
A.4 The LED Display
Upon board restart, the two following messages are shown on the LED
display – each for a while:
LCIC
x.xx x.xx is board’s DSP version.
Sb yyy yyy is current board’s Serial baud-rate
(refer to sections 3.3.1.2 & D.2).
Then the display shows the current data.
Notes
1. The weight on the LED display is always after Filter2
(refer to section 3.3.2.4).
2. In Fill-mode, the LED display shows additional information –
refer to section E.5.
3. During the Fast Mode (section 4.3.4) the LED display is not
updated.