Omega Speaker Systems High Speed Load Cell Interface Card LCIC-WIM-BEN - Manual (Page 22)

21
* The rate of updating the analog output is depends on the
Update Frequency parameter. For example, when Update
Frequency is 4, the analog output is updated 4 times a second.
3.3.1.1 Tools / Analog Output
The ‘Settings’ utility gives access to the analog output mechanism:
Click ‘Tools’ / ‘Analog Output’.
For ‘manual’ mode uncheck the ‘Activate Auto Mode’ box.
For ‘auto’ mode check the ‘Activate Auto Mode’ box.
Manual Mode
On the top of the display, specify a desired voltage in the ‘Manual Mode’
square and click ‘Send’.
Auto Mode
Specify the following parameters:
1. Voltage Max.
2. Weight Max.
3. Weight Min.
4. Update Frequency
The Auto Mode works like this:
* When the current weight = Weight Min. or less, the analog
output is set to 0.
* When the current weight = Weight Max. or more, the analog
output is set to Voltage Max.
* When the current weight is between Weight Min. and Weight
Max., the analog output is set between 0 and Voltage Max., in
the same ratio.