Electrical i/o connections, 1 analog output, Lectrical – Teledyne 460H User Manual
Page 14: Onnections, 1 analog, Output, Figure 2-3 electrical connections, 4 electrical i/o connections, Ac power connector, I/o connector
AC NEUTRAL
EARTH GROUND
AC POWER CONNECTOR
AC LINE
I/O CONNECTOR
Figure 2-3 Electrical Connections
2.4 Electrical I/O Connections
All user I/O connections are available on the 16 pin connector on the mainboard (See
Figure 2-3 for location.) This connector can be unplugged from the header on the
mainboard for easier access when wiring. To disconnect from mainboard, loosen the two
retaining screws at either end of the connector.
When connecting multi-strand wire to this connector, the wire ends should be “tinned”
with solder to ensure a reliable connection. This is not necessary if solid-core wire is
used.
2.4.1 Analog Output
The analog output is located on the two pins labeled ‘Analog Out +’ and ‘Analog Out –‘
The analog output can be configured for voltage or current output. The standard output is
a 0-5 volt output. The analog output can also be optionally configured for a 4-20mA
Current output. Check the serial number tag on the instrument to determine Analog
Output configuration.
P/N 03662D Teledyne API Model 460H O3 Monitor Operator Manual - Page 14