Product preview – Texas Instruments TMS320C6454 User Manual

Page 155

Advertising
background image

www.ti.com

PRODUCT PREVIEW

TMS320C6454

Fixed-Point Digital Signal Processor

SPRS311A – APRIL 2006 – REVISED DECEMBER 2006

7.10.3.2

Programmable Synchronous Interface Timing

Table 7-46. Timing Requirements for Programmable Synchronous Interface Cycles for EMIFA Module

(see

Figure 7-36

)

-720
-850

NO.

UNIT

-1000

MIN

MAX

6

t

su(EDV-EKOH)

Setup time, read AEDx valid before AECLKOUT high

2

ns

7

t

h(EKOH-EDV)

Hold time, read AEDx valid after AECLKOUT high

1.5

ns

Table 7-47. Switching Characteristics Over Recommended Operating Conditions for Programmable

Synchronous Interface Cycles for EMIFA Module

(1)

(see

Figure 7-36

Figure 7-38

)

-720
-850

NO.

PARAMETER

UNIT

-1000

MIN

MAX

1

t

d(EKOH-CEV)

Delay time, AECLKOUT high to ACEx valid

1.3

4.9

ns

2

t

d(EKOH-BEV)

Delay time, AECLKOUT high to ABEx valid

4.9

ns

3

t

d(EKOH-BEIV)

Delay time, AECLKOUT high to ABEx invalid

1.3

ns

4

t

d(EKOH-EAV)

Delay time, AECLKOUT high to AEAx valid

4.9

ns

5

t

d(EKOH-EAIV)

Delay time, AECLKOUT high to AEAx invalid

1.3

ns

8

t

d(EKOH-ADSV)

Delay time, AECLKOUT high to ASADS/ASRE valid

1.3

4.9

ns

9

t

d(EKOH-OEV)

Delay time, AECLKOUT high to ASOE valid

1.3

4.9

ns

10

t

d(EKOH-EDV)

Delay time, AECLKOUT high to AEDx valid

4.9

ns

11

t

d(EKOH-EDIV)

Delay time, AECLKOUT high to AEDx invalid

1.3

ns

12

t

d(EKOH-WEV)

Delay time, AECLKOUT high to ASWE valid

1.3

4.9

ns

(1)

The following parameters are programmable via the EMIFA CE Configuration registers (CEnCFG):

Read latency (R_LTNCY): 0-, 1-, 2-, or 3-cycle read latency

Write latency (W_LTNCY): 0-, 1-, 2-, or 3-cycle write latency

ACEx assertion length (CE_EXT): For standard SBSRAM or ZBT SRAM interface, ACEx goes inactive after the final command has
been issued (CE_EXT = 0). For synchronous FIFO interface with glue, ACEx is active when ASOE is active (CE_EXT = 1).

Function of ASADS/ASRE (R_ENABLE): For standard SBSRAM or ZBT SRAM interface, ASADS/ASRE acts as ASADS with
deselect cycles (R_ENABLE = 0). For FIFO interface, ASADS/ASRE acts as ASRE with NO deselect cycles (R_ENABLE = 1).

Submit Documentation Feedback

C64x+ Peripheral Information and Electrical Specifications

155

Advertising