Texas Instruments TMS320C6454 - Manual (Page 65)

www.ti.com
PRODUCT PREVIEW
3.5 Device Status Register Description
TMS320C6454
Fixed-Point Digital Signal Processor
SPRS311A – APRIL 2006 – REVISED DECEMBER 2006
The device status register depicts the device configuration selected upon device reset. Once set, these
bits will remain set until a device reset. For the actual register bit names and their associated bit field
descriptions, see
Figure 3-10 and Table 3-13 .
Note that enabling or disabling peripherals through the Peripheral Configuration Registers (PERCFG0 and
PERCFG1) does not affect the DEVSTAT register. To determine the status of peripherals following writes
to the PERCFG0 and PERCFG1 registers, read the Peripherals Status Registers (PERSTAT0 and
PERSTAT1).
31 24
Reserved
R-0000 0000
23 22 21 20 19 18 17 16
Reserved EMIFA_EN DDR2_EN PCI_EN CFGGP2 CFGGP1 CFGGP0 Reserved
R-0 R-x R-x R-x R-x R-x R-x R-1
15 14 13 12 11 10 9 8
SYSCLKOUT_
MCBSP1_EN PCI66 Reserved PCI_EEAI MAC_SEL1 MAC_SEL0 Reserved
EN
R-x R-x R-x R-0 R-x R-x R-x R-1
7 6 5 4 3 2 1 0
Reserved LENDIAN HPI_WIDTH AECLKINSEL BOOTMODE3 BOOTMODE2 BOOTMODE1 BOOTMODE0
R-0 R-x R-x R-x R-x R-x R-x R-x
LEGEND: R/W = Read/Write; R = Read only; -x = value after reset
Figure 3-10. Device Status Register (DEVSTAT) - 0x02A8 0000
Table 3-13. Device Status Register (DEVSTAT) Field Descriptions
Bit Field Value Description
31:23 Reserved Reserved. Read-only, writes have no effect.
22 EMIFA_EN EMIFA Enable (EMIFA_EN) status bit
Shows the status of whether the EMIFA peripheral pins are enabled/disabled.
0 EMIFA peripheral pins are disabled (default)
1 EMIFA peripheral pins are enabled
21 DDR2_EN DDR2 Memory Controller Enable (DDR2_EN) status bit
Shows the status of whether the DDR2 Memory Controller peripheral pins are enabled/disabled.
0 DDR2 Memory Controller peripheral pins are disabled (default)
1 DDR2 Memory Controller peripheral pins are enabled
20 PCI_EN PCI Enable (PCI_EN) status bit
Shows the status of which function is enabled on the HPI/PCI multiplexed pins.
0 HPI pin functions are enabled (default)
1 PCI pin functions are enabled
19:17 CFGGP[2:0] Used as General-Purpose inputs for configuration purposes.
These pins are latched at reset. These values can be used by S/W routines for boot operations.
16 Reserved Reserved. Read-only, writes have no effect.
15 SYSCLKOUT_EN SYSCLKOUT Enable (SYSCLKOUT_EN) status bit
Shows the status of which function is enabled on the SYSCLK4/GP[1] muxed pin.
0 GP[1] pin function of the SYSCLK4/GP[1] pin enabled (default)
1 SYSCLK4 pin function of the SYSCLK4/GP[1] pin enabled
Submit Documentation Feedback Device Configuration 65