TANDBERG TT1260 - Manual (Page 52)

Operating the Equipment Locally
Page 3-10 Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder
ST.TM.E10100.1
5 Scroll down to Menu #3.1.7 and edit the
parameter for framesync enable (ENABLED
or DISABLED). Press SAVE. Edits the parameter for framesync enable.
6 Scroll down to Menu #3.1.8 and edit the
PAL framesync offset range (-199999 to
+199999 pixels) and the NTSC framesync
offset range (-199999 to +199999 pixels).
Press SAVE. Edits the PAL framesync offset range and the NTSC framesync
offset range.
7 Scroll down to Menu #3.1.9 and edit the
parameter for delaying 4:2:0 video (0 to
100ms) and the parameter for delaying 4:2:2
video (0 to 100ms). Press SAVE. Edits the parameter for delaying 4:2:0 video and the parameter for
delaying 4:2:2 video.
8 Scroll down to Menu #3.1.10 and edit the
parameter for setting the video monitor
aspect ratio (4:3, 16:9) and video output
level (70 – 130%). Press SAVE. Edits the parameter for setting the video monitor aspect ratio and
video output level.
9 Scroll down to Menu #3.1.11 and edit the
embedded audio data ID (0X0 – 0xFFF) and
audio channel (NONE, ONE, TWO, or ONE
& TWO). Press SAVE. Edits the embedded audio data ID and audio channel.
10 Scroll down to Menu #3.1.12 and edit the
first active video line (22 or 23) and the
parameter for enabling EDH output
(ENABLED or DISABLED). Press SAVE. Edit the first active video line and the parameter for enabling EDH
output.
3.6.3 Selecting the Audio Component
Introduction
Automatic audio component selection is based on component order in the
PMT as follows:
· Audio 1 selects the first component in the PMT and Audio 2 selects the
second component.
· Audio 1 does not select the same component as Audio 2 and vice versa
when component-PIDs are reordered in a new PMT.
· Coding type and language are manually selectable through the user
interfaces by specifying the correct PID.