Setting up async data/sync data, 4 setting up async data/sync data, Selecting the audio manually – TANDBERG TT1260 User Manual
Page 53
Operating the Equipment Locally
Instruction Manual: TT1260 Standard Definition Professional Receiver/Decoder
Page 3-11
ST.TM.E10100.1
Selecting the Audio Manually
It is possible to manually select any audio component from the active
service by using the front panel controls or via the remote control
interface. Select one of the audio components in the list or enter the
correct PID. Table 3.10 describes the procedure for selecting a component
using a Satellite Receiver.
Table 3.10: Manually Selecting the Audio Components
Step
Action
Result
1
Go to the Menu #3.2 and press EDIT. Select
one of the audio streams or enter an audio
PID.
Selects the audio component.
2
Scroll down to Menu #3.2 and edit the Audio
1 delay adjustment (range
± 0 to 49ms).
Press SAVE.
Edits the Audio 1 delay adjustment.
3
Scroll down to Menu #3.2.3 and edit the
Audio 1 digital output format (IEC958 CON,
AES3, or IEC958 AC3) and output routing
(STEREO, MIXED TO BOTH, LEFT TO
BOTH, or RIGHT TO BOTH). Press SAVE.
Edits the Audio 1 digital output format and output routing.
4
Scroll down to Menu #3.2.4 and edit the
clipping value (12 – 24 dB). Press SAVE.
Edits the clipping value.
5
Scroll down to Menu #3.2.5 and edit the
AC-3 downmix parameter (SURROUND
STEREO or CONVENTIONAL STEREO)
Press SAVE.
Edits the AC-3 downmix parameter.
6
Go to the Menu #3.3 for Audio 2 and repeat
steps 2 through 4.
Selects the audio component.
3.6.4
Setting Up Async Data/Sync Data
These menu pages allow status monitoring and configuration of the low
and high speed data.
NOTE…
When the High Speed RS-422 Data Enabler Card (S12595) is detected on power-up the unit will
recover high speed data. If it is not installed the unit will recover low speed data. The unit can recover
either low speed (RS-232) data or high speed (RS-422) data but not both simultaneously.
Table 3.11: Setting Up Async Data/Sync Data
Step
Action
Result
1
Go to Menu #3.4 and press EDIT. Select the
data stream number.
Selects the data stream number.
2
Scroll down to Menu #3.4.1 and edit the
low speed data output (ENABLED or
DISABLED). Press SAVE.
The unit receives and displays the correct bit-rate.