Tascam HS-8 - Manual (Page 51)

TASCAM HS-8
51
When channels are linked
When channels are linked, the screen appears as follows.
Channel setup screen when channels are linked
When channels are linked:
The input source selection button shows the pair of •
channels.
The signal flow line is doubled.
•
A stereo meter (2 bars) is shown. •
Touch the channel name button to show a pop-up with •
buttons for each channel in the pair.
Stereo (L/R) channel
The stereo channel setting (L/R SETUP) screen appears as
follows.
Stereo channel setting screen
The stereo channel has a limiter function. Touch the
LIMITER
button to turn it ON and OFF.
The stereo (L/R) channel does not have input source
selection buttons, a pan pot or an input monitor button.
Digital source settings (CHx-x DIGI SOURCE)
Touch the
DIGITAL SOURCE
button on the channel settings
screen to open the following screen.
AES x-x button (“x” indicates the channel number): Set
AES/EBU digital input channel 1-8 as the input source.
AES A-B button: Set AES/EBU digital input channel A/B as
the input source.
ADAT x-x button (“x” indicates the channel number): Set
ADAT digital input channel 1-8 as the input source.
Fs CONVERT button: Turn the sampling rate converter ON
or OFF.
Level meter settings (METER SETUP)
Make level meter settings on this screen.
Peak Hold Time knob: Touch this to set the peak hold
time. Use the DATA dial to adjust the time. The setting
values are 0 sec, 1 sec (default setting), 2 sec and inf
(hold forever).
Release Time knob: Touch this to set the release time. Use
the DATA dial to adjust the time. The setting values are
Slow
,
Normal
(default setting) and
Fast
.
Over Level knob: Touch this to set the level at which the
overload indicator lights. This is the amount in dB
below the maximum level (full scale). Use the DATA
dial to adjust the level. The setting values are
–0.20 dB
(default setting),
–0.17 dB
,
–0.13 dB, –0.10 dB, –0.06
dB,
or
–0.03 dB
.
This setting is reflected in the Audio Over setting of
the
Auto Marker
item on the
OPTIONS
page of the
REC
SETUP
screen.
Ref. Level Line button: Touch to turn the reference level
line that appears on the level meter ON (default
setting) or OFF.
6 – Internal Settings and Operations