Tascam HS-8 - Manual (Page 61)

TASCAM HS-8
61
If the operation of this unit becomes irregular, please
check the following things before requesting repair. If the
following measures do not resolve the problem, contact
the store where you purchased the device or a TEAC
Repair Center
Power does not turn on. ª
Confirm that the power plug, for example, is connected •
completely.
Media is not recognized. ª
Confirm that the CF card is securely inserted into the •
CF slot.
Pause recording or playback.
•
The unit does not function. ª
Is the panel lock function ON? •
Playback is not possible. ª
Confirm that the file is of a compatible •
sampling frequency (44.1/48/48 pull-down/48
pull-up/88.2/96/176.4/192 kHz) and bit rate (16/24).
There is no sound. ª
Reconfirm the connections of your monitoring system •
and check the level of your amplifier.
Confirm that the “Level” setting on the HOME (PAN/
•
LEVEL) screen is not lowered.
If you are using an RC-HS20PD, confirm that the fader is
•
not lowered.
If you cannot hear the input signal, arm recording and
•
turn input monitoring ON.
If you cannot hear the playback sound, turn input
•
monitoring OFF.
Check the online function and online playback mode
•
settings.
Recording is not possible. ª
Reconfirm connections. •
Adjust the recording levels. •
If the CF card does not have enough capacity, erase •
unneeded data and increase the amount of open space
or change the CF card.
If the maximum number of recordable takes or the
•
maximum take number has been reached, change the
recording folder.
If the total number of items in the folder, including
•
files and subfolders is too large, change the recording
folder.
Setting changes that I made are not ª
remembered.
This unit backs up settings whenever the CF card •
selection is changed, a project, folder or take is loaded,
and playback or recording occurs. After startup, if none
of these actions is conducted, settings might not be
backed up even if they are changed.
I hear noise. ª
Confirm that all cable connections are secure. •
The touch panel does not work properly. ª
Do not use commercially-available protective film for •
LCD screens on the touch panel.
Confirm that the panel lock function is not engaged
•
and locking the display.
I cannot create a new project. ª
Confirm that a project with the same name does not •
already exist.
If the amount of space remaining on the CF card is
•
too small, a new project cannot be created. Erase
unnecessary data and then try again.
11 – Troubleshooting