Tektronix MTM400 - Manual (Page 152)

Interface Configuration and Interpretation
3-108 MTM400 MPEG Transport Stream Monitor User Manual
To summarize:
ƒ
All cards can be selected and configured using the configuration screen (use
the Config button).
ƒ
The results and measurements of the installed card can be observed using the
Input Card button.
ƒ
CIP card configuration, results and measurements can all be done using the
Input Card button.
The Input Card button on the button bar will be inactive (that is, dimmed) if an
interface card is fitted, but not selected in the Configuration screen. The button will
not be present if no interface card is installed. Also, when active, the button will
only display red and green states; this indicates the interface card stream lock
status (also displayed on the configuration screen).
In the Input Card screen, the settings area (right-hand side) contains two sub-areas.
The Readings area displays values received from the card itself. A yellow
background to the reading indicates that the reading has not been recently updated.
The Controls area contains user controls; values entered here will be applied to the
card and affect its performance. These controls correspond exactly with those on
the corresponding configuration screen.