Tektronix MTM400 - Manual (Page 55)

Device View
MTM400 MPEG Transport Stream Monitor User Manual 3-7
Set Time… Allows the RTM device time to be set.
(See Set Time, page 3-9.)
Upload Device Firmware…
Allows new firmware to be uploaded to overwrite the existing
device firmware.
(See Firmware Upload, page 3-11.)
Upload I/F Card Firmware…
Allows new firmware to be uploaded to overwrite the existing
interface card firmware.
(See Firmware Upload, page 3-11.)
Set Device Passwords
Allows the RUI passwords to be set.
(See Passwords, page 3-13.)
Reset Device Resets the MTM400 by rebooting. The configuration is reloaded
from non-volatile RAM; any configuration settings not saved
before the reset will be lost.
(See Device Reset, page 3-13.)
Upload License…
Allows the License Key details to be entered.
(See Upload License, page 3-14.)
Network Settings
Although the MTM400 network identity is initially set up during installation, it can
be changed subsequently through the Network Settings dialog.
SNMP community strings can also be set using the Network Settings dialog box.
In all cases, when the values have been changed as required, select the adjacent Set
button to store the new settings in the MTM400.
To open the Network Settings dialog, select Network Settings from the Device
Configuration dialog.