Tektronix MTM400 - Manual (Page 66)

Stream View
3-18 MTM400 MPEG Transport Stream Monitor User Manual
Tests Displays the state of the tests applied to the stream. It also
allows users with read-write permissions (Administrators) to
configure alarms and relays and parameters associated with each
test.
(See page 3-23.)
Information Displays events not normally logged in the Stream log; for
example, PAT/PMT version changes.
(See page 3-28.)
Custom Displays the state of the tests in the same way as the Tests view,
but categorized as Critical, Major, Minor or Warning.
The allocation of tests to categories is preconfigured, but you
can override the settings at run time. However, the settings will
not be saved when the RUI is closed (using the WebMSM
allows permanent configurations to be saved).
(See page 3-26.)
Programs Displays the programs that are being transmitted on the stream
along with bit rate and the minimum and maximum bit rates that
are observed. Administrators can set bit rate limits for each
program if the bit rate limits option is licensed.
(See page 3-30.)
PIDs Displays the PIDs that are being transmitted on the stream along
with bit rate and the minimum and maximum bit rates that are
observed. Administrators can set bit rate limits for each PID if
the bit rate limits option is licensed.
(See page 3-34.)
PID Groups * Displays the PID groups that you have created. The displayed
information includes the error state and the bit rate.
(See page 3-41.)
PCR Jitter * Displays the following PCR graphs: Inaccuracy, Arrival, Overall
Jitter, Frequency Offset, and Drift Rate.
(See page 3-48.)
SFN Displays the Single Frequency Network (SFN) information
when available.
(See page 3-56.)
TMCC Displays the Transmission and Multiplexing Configuration
Control (TMCC) and IIP information when available.
(Only available for ISDB streams)
(See page 3-57.)