Appendix a: network installation – Tektronix MTM400 User Manual
Page 183
Appendix A: Network Installation
A-6
MTM400 MPEG Transport Stream Monitor User Manual
Removing the Cover
The unit cover is held in position by 21 x T10 Torx screws.
1.
Remove and retain the 21 cover retaining screws.
2.
Lift the cover from the unit.
Resetting the Non-Volatile RAM
Locate and press the Non-Volatile RAM Reset switch (SW111). This action
resets the non-volatile RAM and clears the current configuration. As part of
this action, the IP address is reset to 0.0.0.0.
NOTE. Another consequence of clearing the non-volatile RAM is the loss of the
licensing information; the license key must be reentered after setting the IP
address.
1
2
6
Additional
information
found on label
on top panel
100-240 VAC 50/60 Hz
1A MAX
Serial No.
Tektronix Inc. Beaverton OR.
U.S.A.
00-01-F8-A7-33-
CC
LAN
LTC
IN
QPSK (L-BAND)
OUT
ASI/
SMPTE
ALARMS
IN
OUT
IN
LOCK
LNB
POWER
Figure A-2: Transport stream processor reset switches
SW111
Non-Volatile
RAM Reset
SW110
Processor
Reset