Tektronix MTM400 - Manual (Page 42)

Operating Basics
2-8 MTM400 MPEG Transport Stream Monitor User Manual
PCR Jitter * Displays the following PCR graphs: Inaccuracy, Arrival, Overall
Jitter, Frequency Offset, and Drift Rate.
(See page 3-48.)
SFN Displays the Single Frequency Network (SFN) information
when available.
(See page 3-56.)
TMCC Displays the Transmission and Multiplexing Configuration
Control (TMCC) and IIP information when available.
(Only available for ISDB streams)
(See page 3-57.)
SI Graphs * Displays information about repetition rates of SI tables and
subtables in graphical format.
(See page 3-58.)
SI Tables * Displays the SI Information for the stream.
(See page 3-62.)
Template * Displays the structure and status of templates applied to the
stream.
(See page 3-68.)
Recording * Displays the Triggered Recording setup screen.
(See page 3-71.)
Log Displays the stream log.
(See page 3-72.)
Config Displays general configuration parameters for the stream.
Administrators can modify certain parameters. Scheduling,
triggered recording, and interface setup are configured here.
(See page 3-76.)
Service Log Displays the Service Log. Service logging allows packet counts
for specified PIDs (range: 0 to 100) to be collected at a user-
definable interval.
(See page 3-80.)
Input Card Displays the relevant graphs and setup of any installed interface
card. (Only displayed if an interface card is present.)
(See page 3-107.)
* - licensed options (see Table 1-5: MTM400 Options Summary).