Tektronix MTM400 - Manual (Page 27)

Getting Started
MTM400 MPEG Transport Stream Monitor User Manual 1-13
Powering Up the MTM400
After the connections have been made to the unit, all that is required to power up
the MTM400 is to apply power. Connect the power cord to a properly grounded
outlet. Connect the other end of the cord to the product's power input
(see Figure 1-1).
There is no mains disconnect switch. Initialization will begin as soon as power is
connected to the power input. The LEDs on the front panel will indicate activity
(see Local Indicators, page 2-2). Initialization can take up to 60 seconds.
Disconnect the power cord to remove power.