TC electronic SDN BHD M3000 - Manual (Page 12)

10
Bank indicator
(RAM/ROM/CARD) Engine 1
Engine 2
Algorithm type Primary parameter Edited flag Preset number
The Recall Displays
The Recall displays are the "homepage" of the M3000. Whenever you exit any other display this is where you return to.
As illustrated below the Recall display holds a few of the most important parameters for each of the two Engines at the same time.
Engine 1 is always displayed in the upper section and Engine 2 in the lower.
The "Edited flag" shows an E when you have changed a parameter in the preset. (See ill.)
Recalling a Preset
Press the RECALL key on Engine 1 or 2 and scroll
through the presets using the ADJUST wheel.
Press OK to recall when you find the desired preset.
You are able to search for another preset before recalling it. This
is called previewing.
Until you press OK you are previewing. At this point your
OK key is blinking, indicating that the preset displayed is not yet
recalled (active).
Use the CURSOR keys (or the other RECALL key) to access the
other Engine.
You can also use the Wizard to recall presets.
(See "The Wizard" on page 14).
If you wish to return to the original preset after
editing various parameters without storing your
changes, simply press the RECALL key on the
appropriate Engine followed by OK.
Primary parameters
Preset name
Recall Display
Combined Recall Display
Routing mode
RECALL
10