TC electronic SDN BHD M3000 - Manual (Page 41)

39
VSS™FP - FILM & POST
VSS™FP
The VSS™FP (Film & Post-Production) reverb algorithm is a
special version of VSS™3, incorporating dedicated Early
Reflection types for motion picture use, e.g. Car, Bathroom
and Conference Rooms.
VSS™FP Reverb
Decay
(0.01 - 20s) The Decay time of the Reverb. Usually
associated with the time it takes the Reverb tail to decay
60dB. This is the overall Master Decay for the four band
Decay parameters (found in the REVERB section below)
which are multiples of this base Reverb time.
Hi Color (available in easy mode only)
Adjusts the spectral balance in the high end frequencies.
This is actually a simple way of adjusting a complex
selection of frequencies.
Lo Color (available in easy mode only)
Adjusting the spectral balance in the low end frequencies.
A simple way of adjusting a complex selection of
frequencies.
Position (available in easy mode only)
Changes the distance from the listener to the source.
The characteristics of the room are preserved, only the
perceived distance changes.
Note: To obtain the intended effect, please do not use a 100%
wet mix, but include some dry signal.
Early Lev
(-100dB - 0dB) The Output level of the Early Reflections.
When Early Lev is set to off the Reverb effect will consist
entirely of Reverb “tail”.
Rev Lev
(-100dB - 0dB) The Output level of the Reverb tail. When
Rev Lev is set all the way off, the effect will consist entirely
of Early Reflections.
Rev Delay
(0 - 200ms) A delay to the tail of the reverb. Adds
additional time between the Early Reflections and the onset
of the "tail" of the reverb.
Pre Delay
(0 - 100ms) A delay placed at the Input of the algorithm. This
sets how long after the dry sound the Early Reflections will
begin.
Mix
(0% - 100%) Wet/Dry mix. Can be frozen at 100% on the I/O
menu.
Out Level
(-100dB - 0dB) The overall Output level of the Reverb.
This is mostly used when the two Engines are used in serial
mode, or used in the Combined Mode.
Expert mode
Press OK to gain access to the following additional
parameters.
Note: Hi Color, Lo Color and Position are not available in
this mode.
Early Reflections
Early Type
(Several types)
Pick the type that best compliments your material or best
represents the effect you are going for.
Early Size
(Small, Medium, Large)
Changes the size of the Early Type parameter.
Note: Some of the Early Types are only one size.
Early Pos
Here you can select between a Close and a Distant setting.
This enables you to change the distance between the listening
position and the source in the same Early Reflection pattern.
Note that some of the Early Types only have one position
available.