TC electronic SDN BHD M3000 - Manual (Page 51)

49
Chorus
These presets are capable of producing a smooth natural
sounding stereo Chorus effect. The Hi Cut filter gives you
the ability to make the Chorus very warm.
Speed
The speed of the Chorus, also known as Rate.
Depth
Adjusts the depth of the Chorus, also known as Intensity.
Delay
As described earlier, a Chorus/Flanger is basically a Delay
being modulated by an LFO. This parameter makes it
possible to change the length of that Delay. A typical Chorus
uses delays at approximately 10ms, while a Flanger uses
delays at around 5ms.
Mix
Mix between direct sound and effect.
Out level
Adjusts the Output level of the Chorus.
Golden ratio
Sets the Golden Ratio between Speed and Depth On/Off. If
you want to create wild Chorus sounds you may want to turn
the Golden Ratio off.
Phase Reversed
Reverses the phase of the right channel, but only on the
effect signal. This function makes the stereo image much
wider.
LFO Curve
Sets the curve of the LFO. Choose between Sine or Triangle.
The most commonly used waveform in Chorus is Sine.
(see curve figures in Tremolo).
LFO Phase
An LFO phase change causes a small delay in one of the
waveform starting points. This means that left and right
Outputs start the current waveform at two different points.
Example: If LFO phase is set to 180º, left and right will be
exactly opposite.
Flanger
The Feedback filters in this algorithm are capable of control-
ling both high frequency and low frequency feedback, which
makes it very flexible and versatile.
Speed
The speed of the Flanger, also known as Rate.
Depth
Adjusts the depth of the Flanger, also known as Intensity.
Delay
As described earlier, a Chorus/Flanger is basically a Delay
being modulated by an LFO. This parameter makes it
possible to change the length of that Delay. A typical Chorus
uses delays at approximately 10ms, while a Flanger uses
delays at around 5ms.
Mix
90 phase
change
ADDITIONAL EFFECTS - CHORUS & FLANGER