TC electronic SDN BHD M3000 - Manual (Page 26)

24 24
EDIT
The Output levels for Engine1 and 2 can be adjusted individually
or simultaneously.
Use the CURSOR keys to select either Engine 1 or Engine 2, and
the ADJUST wheel to change value.
Placing the cursor between the L and the R allows you to adjust
the L/R levels simultaneously.
The Engine Out Levels are identical with the Out Level parame-
ter in the Edit page and will always be corresponding with these.
Exercise 5 :
How to edit a preset
- Select Engine 1 by pressing its RECALL key. Use the
ADJUST wheel and select ROM preset #2.
- Press the OK key to confirm and recall the preset.
- Press the EDIT key in the Engine 1 section. You are now in
the User Edit mode.
- Use the CURSOR keys to select the parameter you wish to edit.
- Select e.g. Decay. Change the value using the VALUE key.
Press the STORE key (still in the Engine 1 section), and select
the location where you want the preset to be stored by turning
the ADJUST wheel.
- Press OK to confirm. In this process you can also change the
name of the preset (see the “Store” chapter on page 13).
Edit
In the Edit display you use the CURSOR keys to select
parameters and the ADJUST wheel to change values.
In the VSS™ algorithm presets there are two Edit
modes: User and Expert.
Easy mode
The first time you edit a VSS™ preset, this is the mode you
enter. The Easy mode holds the most important parameters such
as Decay.
Expert mode
Select the Expert mode by placing the cursor at the Expert mode
line and press OK.
The Expert mode allows you to edit a long variety of parameters,
not available in the normal Edit mode.
Note: Since the two Edit modes are not compatible, it is not pos-
sible to return to the User Edit mode once you have stored a pre-
set using the Expert mode.
Combined Edit
The relative Output levels of the two Engines can be adjusted in
this display.
The range is: Off - 0.0dB.
These levels affect both the Analog and Digital Outputs.
Parameter
names
Preset name
Parameter
value
CURSOR