TC electronic SDN BHD M3000 - Manual (Page 38)

36
Hi Color (available in easy mode only)
Adjusts the spectral balance in the high end frequencies
This is actually a simple way of adjusting a complex selec-
tion of frequencies.
Lo Color (available in easy mode only)
Adjusts the spectral balance in the low-end frequencies
A simple way of adjusting a complex selection of frequen-
cies.
Expert mode
Press OK to gain access to the following additional
parameters.
Note: Hi Color and Lo Color is not available in this mode.
Early Reflections
Early Type
(Several types) Pick the type that best compliments your
material or best represents the effect you are going for.
Early Bal
(-100dB R, center, -100dB L) The left/right balance of the
Early Reflections. Allows you to offset the Early
Reflections from the normal center position.
Color
(±50) Adjust the spectral balance of the Early Type.
Low Cut
(20Hz - 400Hz) This adjustable filter removes low
frequencies for the Early Reflections.
Gate Type
(Level, Decay, Both) Selects what the Gate shall work on:
Level takes down the Output level like a normal gate. Decay
rolls off the Decay time according to the Gate Decay setting,
but leaves the Output level unattached. Both will do Output
level roll off and Decay roll off at the same time.
Decay
(0.01 - 20s) The Decay time of the Reverb. Usually
associated with the time it takes the Reverb tail to decay
60dB. This is the overall Master Decay for the four band
Decay parameters. (found in the REVERB section below)
who are multiples of this base Reverb time.
Early Lev
(-100dB - 0dB) The Output level of the Early Reflections.
When Early Lev is set to off the Reverb effect will consist
entirely of Reverb “tail”.
Rev Lev
(-100dB - 0dB) The Output level of the Reverb tail. When
Rev Lev is set all the way off the effect will consist entirely
of early reflections.
Mix
(0% - 100%) Wet/Dry mix. Can be frozen at 100% on the I/O
menu.
Out Level
(-100dB - 0dB) The overall Output level of the entire Reverb.
This is mostly used when the two Engines are set in serial
mode, or used in the Combined mode.
Rev Delay
(0 - 200ms) A delay to the tail of the Reverb. Adds additional
time between the Early Reflections and the onset of the “tail”
of the reverb.
Pre Delay
(0-200ms) A delay placed at the Input of the algorithm. This
sets how long after the dry sound the Early Reflections will
begin.
36
VSS™GATE