TC electronic SDN BHD M3000 - Manual (Page 47)

45
Imposes the characteristics of the Early Reflections on the
later reverberation.
Rev diff 2
Imposes the characteristics of the Early Reflections on the
later reverberation.
Rev width
This parameter adjusts the stereo width of the Reverb tail.
Hi Cut level
Damping Ratio in dB of the Hi Cut filter.
Hi Damp
(0.01 - 2.5) Multiplier for the frequencies above the
Hi Crossover frequency. Example: If the main Decay
parameter is set to 2.0sec and the Hi Decay parameter is set
to 1.5, frequencies above the Hi Xover will decay for 3.0sec.
Conversely if this parameter is set to 0.5 the Decay time
above the Hi Xover point will be 1sec.
Hi Decay
Adjusts the high frequency reverberation time.
Hi Crossover
Crossover frequency between mid and high band
reverberation filter.
Lo Decay
Adjusts the low frequency reverberation time.
Lo Crossover
Crossover frequency between low and mid band
reverberation filter.
C.O.R.E.
The C.O.R.E. algorithm is a well-known TC Reverb from the
M5000, and is very good on short to medium decay times.
C.O.R.E. has all parameters present at first layer (meaning no
Expert mode).
Try e.g. presets 69, 89 and 189 to experience the C.O.R.E
algorithm.
Decay
Sets the Decay time. The value indicates the time to where
the Reverb tail is damped to -60dB.
Early Level
Sets the Early Reflection level.
Reverb Level
Level of the Reverb tail.
Mix
Mix between direct and effect.
Out Level
Adjusts Output level. Use this parameter to match levels
between presets.
Rev Delay
Determines how fast the reverberation will build up.
Pre Delay
The time to arrival of the first reflection.
Reflections
Room shape
Here you can choose between different room shapes.
Changing the room shape will change the Early Reflections.
Size
Size multiplication factor. With this parameter you can
change the size of the room. Only the Early Reflections are
influenced by this factor.
Rev diff 1
C.O.R.E.