TC electronic SDN BHD M3000 - Manual (Page 37)

35
Reverb Mod
Type
(Off, Smooth 1, Smooth 2, Perc, Wow, Vintage, Wild)
Adjusts the type of modulation.
Rate
(-100, default, +100) Allows you to offset the speed of the
LFO from the factory default assigned to each Type.
Width
(0% - 200%) Sets the Width of the modulation.
Space Mod
This group of parameters sets the way the sound moves about
the room.
Type
(Off, Normal, Fast, Slow, MidFreq, Sync).
Rate
(-100, default, +100) Allows you to offset the speed of the
LFO from the factory default assigned to each type.
Width
(0% - 100%) Sets the width of the modulation.
Depth
(-50, default, +50) Allows you to offset the amount of space
modulation from the factory default.
VSS™Gate
The VSS™ algorithm with Gate parameters added. The Gate
function is very comprehensive, and opens up a lot of
opportunities in combination with the reverb.
The user interface is split into two levels: Easy mode, which
gives access to the most common parameters, and
Expert mode with additional parameters available.
Threshold
When the Input signal falls below this Threshold, the Gate
starts working. This means that the higher Threshold the
more expansion you will get.
Attack
The Attack is the time that the Gate uses for
bringing the reduced signal to 1:1, when the signal exceeds
the Threshold.
Hold
Is the time that the Gate will keep the Ratio at 1:1 below the
Threshold, before the Release time sets in.
Release
The Release time is the fallback time that the Gate uses to
close.
Retrig
(On/off) When set to ON the gate works as a normal gate,
when set to OFF the gate will run the whole “Attack, Hold,
Release” time-cycle before it will be possible to retrig the
gate again. This feature is very useful when working with
percussive material.
Gate Decay
(0.10 - 1.00) From the Release point, the gate takes down the
Output level, but at the same time it’s possible to roll-off the
Decay Time in the tail (See the GateType parameter). This
parameter is a multiplier on the Decay time that sets in from
the start of the Release time. This allows you to “empty” the
tail at the Release time so no leftovers are heard when the
gate opens again.
Max Att
(0dB - 100dB) Max attenuation of the Gate.
VSS™GATE