TC electronic SDN BHD M3000 - Manual (Page 48)

46 46
Hi Decay
Adjusts the high frequency Reverberation time.
Hi Crossover
Crossover frequency between mid and high band
Reverberation filter.
Mid Crossover
Crossover frequency between low-mid and high-mid band
Reverberation filter.
Lo Mid Decay
Adjusts the mid frequency Reverberation time.
Lo Crossover
Crossover frequency between low and mid-band
Reverberation filter.
Lo Decay
Adjusts the low frequency Reverberation time.
Modulation
Rate
The Mod Rate varies the Rate of modulation of the
recirculating delay paths simulating the Reverb tail.
Depth
Controls the amount of Delay Path Modulation or “wander”
in the reverb.
Rev-3 :
Reverb 3 is a well known TC algorithm from the M5000, and
is very good at medium decay times. Rev-3 has all parame-
ters present in the first layer (meaning no Expert mode).
Try e.g. presets 77, 81, 83 and 84 to experience the Rev-3
algorithm.
Pre Delay
The time to arrival of the first reflection.
Decay
Sets the Decay time. The value indicates the time to where
the Reverb tail is damped to -60dB.
Distance
The relative distance control varies the mix relations between
early and later reflections. Simulating how far away you are
from the sound source.
Mix
Mix between direct and effect.
Out Level
Adjusts Output level. Use this parameter to match levels
between presets.
Diffuser type
The natural room mode peak frequencies and the smoothness
of the tail are affected by this parameter.
Diffuse
This parameter sets the degree of wall diffusion. Increasing
the value will result in a more dense Reverberation tail.
Do not set the value too high, as it will result in an unnatural
sounding Reverberation tail.
Hi Cut freq.
Sets the cut-off frequency of the Hi Cut filter.
Hi Damp
(0.01 - 2.5) Multiplier for the frequencies above the
Hi Crossover frequency. Example: If the main Decay
parameter is set to 2.0sec. and the Hi Decay parameter is set
to 1.5, frequencies above the Hi Xover will decay for 3.0sec.
Conversely if this parameter is set to 0.5 the Decay time
above the Hi Xover point will be 1sec.
REV-3