True Manufacturing Company TD-50-18-S-LT - Manual (Page 11)

............ www.truemfg.com ............ 9 9
True Food Service Equipment, Inc.
............ www.truemfg.com ............
INSTALLATION / OPERATION INSTRUCTIONS
A. Before your new unit is connected to a power supply,
check the incoming voltage with a voltmeter. If
anything less than 100% of the rated voltage for
operation is noted, correct immediately.
B. All units are equipped with a service cord, and must
be powered at proper operating voltage at all times.
Refer to cabinet data plate for this voltage.
TRUE recommends that a sole use circuit be dedicated
for the unit.
WARNING
Compressor warranties are void if compressor burns out due
to low voltage.
WARNING
Power supply cord ground should not be removed!
WARNING
Do not use electrical appliances inside the food storage
compartments of the appliances unless they are of the
type recommended by the manufacturer.
NOTE
To reference wiring diagram - Remove front louvered grill,
wiring diagram is positioned on the inside cabinet wall.
ELECTRICAL INSTRUCTIONS
On direct draws, the drain is located at the front
of the cabinet. To plumb in the drain, connect 3 ⁄
4
"
(2cm) P.V.C. pipe to the 3 ⁄
4
" (2cm) barbed fitting
supplies with the unit.
CO2 PRESSURE
Mobile tapsters, to retain complete mobility, the
CO2 tank (up to five pounds in size) can be
placed inside the cooler (strap holders furnished).
CAUTION
Filled CO2 tanks are potentially dangerous because
of the pressure they contain. If you are unfamiliar
with their use or the use of the CO2 regulator, seek
information from your local distributor, or your local
beverage man before proceeding.
INSTALL DRAFT ARM
Place rubber washer over draft arm mounting
holes in cabinet, put beer line connector down
through hole. Next, secure draft arm with four
screws. (See images 1-6)
DIRECT DRAW DRAFT ARM INSTALLATION
CONTINUED ON
NEXT PAGE...
Draft arm install contents.
(Draft arm not shown)
Beer line
connector.
Thread beer line connector to draft arm and secure draft arm
to cabinet with rubber gasket under the draft arm.
Thread beer
draft arm
handle onto
the draft
arm.
1
2
3 4 5
6