True Manufacturing Company TD-50-18-S-LT - Manual (Page 7)

............ www.truemfg.com ............
INSTALLATION / OPERATION INSTRUCTIONS
True Food Service Equipment, Inc.
5 5
TOOLS REQUIRED:
• Phillips screw driver
• 3/8” socket or 3/8” wrench
A. Use a phillips screw diver and remove four screws
from the L-bracket connected the unit to the wood
skid (see image 1). Then use a 3/8” socket or wrench
and remove the L-bracket from the unit
(see image 2).
When lifting unit do not use the countertop as
a lifting point. Also remember to leave cabinet upright
for 24 hours before plugging into power source.
B. Remove skid by unscrewing all base rail anchor
brackets. Place skid to the side.
C. Carefully upright cabinet.
D. Applicance tested according to the climate classes 5
and 7 for temperature and relative humidity.
LOCATING
Removing
bracket from
skid.
Removing bracket
from cabinet.
1
2
A. Set unit in its final location. Be sure there is adequate
ventilation in your room. Under extreme heat
conditions, (100°F+, 38°C+),
you may want to install an exhaust fan.
WARNING
Warranty is void if ventilation is insufficient.
B. Proper leveling of your TRUE cooler is critical to
operating success (for non-mobile models). Effective
condensate removal and door operation will be
effected by leveling.
C. The cooler should be leveled front to back
and side to side with a level.
D. Ensure that the drain hose or hoses are positioned in
the pan.
E. Free plug and cord from inside the lower rear
of the cooler (do not plug in).
F. The unit should be placed close enough to the
electrical supply so that extension cords are never
used.
WARNING
Cabinet warranties are void if OEM power cord is tampered
with. True will not warranty any units that are connected to
an extension cord.
LEVELING
These instructions explain how to keep door in open
position.
A. Slide the door open.
B. Latch the door in the open position from the
back side of door (notch in track).
C. Door latch in image 1 is in the open position.
D. Door latch in image 2 is in the closed position.
SLIDE DOOR UNITS WITH HOLD OPEN FEATURE
1
2
(Rear view of door & track)