True Manufacturing Company TD-50-18-S-LT - Manual (Page 12)

............ www.truemfg.com ............ 10 10
True Food Service Equipment, Inc.
INSTALL DRAFT ARM continued...
Insert air hose (one inch plastic tube)
in draft arm, being careful not to disturb
insulation. Remove top cover of draft arm
and attach air hose clip to the insulating
sleeve at the top of the draft arm. Replace
top cover. The air hose clip will assure that
the hose remains
in proper place at all times, keeping
the beer faucet cold. (See image 7-9)
............ www.truemfg.com ............
INSTALLATION / OPERATION INSTRUCTIONS
DIRECT DRAW DRAFT ARM INSTALLATION
CONTINUED...
A. The compressor is ready to operate. Plug in the
cooler.
B. Temperature control set at No. 4 position gives
refrigerators an approximate temperature of 35°F and
glass chiller frosters have an approximate temperature of
0°F. Allow unit to function several hours, completely
cooling cabinet before changing the control setting.
C. Excessive tampering with the control could lead to
service difficulties. Should it ever become necessary
to replace temperature control, be sure it is ordered
from your TRUE dealer or recommended service
agent.
D. Good air flow in your TRUE unit is critical. Be
careful to load product so that it neither presses
against the back wall, nor comes within four inches of
the evaporator housing. Refrigerated air off the coil
must circulate down the back wall.
LIGHT SWITCH LOCATION:
The switch is located on the front of the evaporator
housing toward the front of the cabinet. Open the front
doors and the switch will be visible close to the ceiling
the cabinet.
NOTE
If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION
Before loading product we recommend you run your TRUE
unit empty for two to three days. This allows you to be sure
electrical wiring and installation are correct and no shipping
damage has occurred. Remember, our factory warranty does
not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for
your cooler. If at any time during the life of your cooler, a
part is needed, you may obtain this part by furnishing the
model number and serial number to the company from whom
you purchased the cooler. Call Toll-Free: (800)-424-TRUE
(Direct to Parts Department). (800)-325-6152 (U.S.A.
& Canada only) or call: (636)-240-2400.
STARTUP
7 8 9