True Manufacturing Company TD-50-18-S-LT - Manual (Page 8)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
6 6
INSTALLATION / OPERATION INSTRUCTIONS
STEP 2
Using a 7/16” wrench or adjustable wrench
and 1/8” allen wrench loosen roller and move
along slotted hole. After adjustment has been
made tighten the
roller into place.
See image 9.
Image 9
TO ADJUST SLIDE DOOR
STEP 6
Remove door cord from roller bracket. The
black plastic tab holding the door cord slides out
the back. Slowly let the door cord retract back
to the track. See image 6.
STEP 7
When reinstalling door make sure door cord
grommet attaches to roller slot closest to pulley.
(See image 7 and 8).
STEP 1
After cabinet is installed in a final location and
correctly leveled check for any openings when the
slide doors are completely closed. If there are
any gaps/openings between the closed doors
and cabinet, the doors will need to be
adjusted.
Image 3 (Three Door Units ONLY)
STEP 1
Doors can not be removed unless placed in
specific locations stated in these instructions.
STEP 2
Two Door Units: Slide the front door so it is
centered on the cabinet. The door can not be
removed unless it is centered. See image 1 for
door channel openings and image 2 for
centering door.
Three Door Units: Slide the middle door to
the right so it is centered with the left edge of
the right door. See image 3.
Image 1 (Two Door Units ONLY)
Image 2 (Two Door Units ONLY)
CENTERED DOOR
Image 5 (Three Door Units ONLY)
STEP 5 (Three Door Units Only)
Slide left door to the right so right edge lines up
with the right edge of the True Logo located at
the top of the door frame. See image 5b. Then
lift door out of track as described in Step 3.
STEP 4 (Three Door Units Only)
Slide right door to the left so left edge lines up
with the left edge of True Logo located above the
door. See image 5a. Then lift door out of track as
described in Step 3.
STEP 3
After centering the door lift it up and tilt top of
door towards the back of the unit so the rollers are
out of the top channel. Swing the bottom of the
door out of the bottom channel. Then remove the
door and set it down. See image 4.
(TWO DOOR UNITS SKIP TO STEP 6)
Image 4
Image 6
SLIDE DOORS
Image 5a
Image 5b
Image 7 (Door closing to the right)
Image 8 (Door closing to the left)