Toshiba G7 - Manual (Page 10)

G7 ASD Multi-Protocol Communication Option and PG Feedback Option Manual 3
2.2 Maintenance Precautions
• Use lockout/tagout procedures on the branch circuit disconnect before servicing
the ASD or installed option.
• The ASD maintains a residual charge for a while after turning the ASD off. Wait
at least ten minutes before servicing the ASD after turning the ASD power off.
Ensure that the Charge LED is off.
• Do Not attempt to disassemble, modify, or repair the option card. Call your
Toshiba sales representative for repair or service information.
• Turn the power on only after attaching the front cover and Do Not remove the
front cover of the ASD when the power is on.
• If the ASD should emit smoke or an unusual odor or sound, turn the power off
immediately.
• The heat sink and the discharge resistors may become extremely hot to the touch.
Allow the unit to cool before coming in contact or performing service on the ASD
or option card.
• The system should be inspected periodically for damaged or improperly
functioning parts, cleanliness, and to determine that the connectors are tightened
securely.
2.3 Inspection
Upon receipt, perform the following checks:
• Inspect the unit for shipping damage.
• Check for loose, broken, damaged or missing parts.
Report any discrepancies to your Toshiba sales representative.
2.4 Storage
• Store the device in a well ventilated location (in its shipping carton, if possible).
• Avoid storage locations of extreme temperatures, high humidity, dust, or metal particles.
2.5 Disposal
• Contact the local or state environmental agency in your area for details on the disposal of
electrical components and packaging.
• Do not dispose of the unit via incineration.