Toshiba G7 - Manual (Page 12)

G7 ASD Multi-Protocol Communication Option and PG Feedback Option Manual 5
4. Installation
4.1 Installation Procedure
The interface cards for the G7 ASD have been designed for quick and simple installation. The card is
connected to the drive's control board via an 80-pin connector, and is mechanically supported with
nylon standoffs attached through the control PCB to the chassis. The only tools required for installation
are a flat screwdriver, a #2 Phillips screwdriver and, for most installations, a utility knife to aid in the
removal of the front cover's side access window. Each interface card kit includes one #51326A
connector PCB and four #47220 nylon hex standoffs.
Before opening the drive, please observe all safety precautions as outlined on the unit's front cover and
in the operation manual. After securing the unit against hazardous voltages, loosen the two lower
fasteners and remove the cover, taking care not to damage the keypad-to-drive cable connection.
Remove the four pan head screws that secure the control PCB to the drive (refer to Figure 1) and replace
with the #47220 1/2" hex standoffs provided. Make these substitutions one or two fasteners at a time to
prevent any shifting of the control board.
#51326A
#47220
#47220
Figure 1: Screw Removal, Standoff and Connector PCB Installation