Tascam 788 - Manual (Page 102)

12 – MMC and MIDI functions–MIDI Machine Control
102
TASCAM 788 Digital PortaStudio
788 MMC slave/master setting
To set the 788 as either an MMC slave or master, fol-
low the steps below.
1 With the transport stopped, press the MENU
key.
2 Use the dial to scroll down to the SYNC/
MIDI menu and press ENTER .
3 Use the dial to scroll down to the CONTROL
menu item and press ENTER .
4 There are two tabs on this screen. Use the Ó
key to ensure that the
MMC tab is visible.
5 Use the § and ¶ keys to highlight the MODE
menu item.
6 Use the dial to select the appropriate setting:
7 Press ENTER to confirm the setting.
NOTE
If the 788 is set up as an MMC slave, this does not disable
the local transport controls. You can still use these controls
to play, record, locate, etc.
MMC ID
You can set an MMC ID for the 788. This ID can be
used to distinguish it from other units in the control
chain, and to receive messages which are intended
only for it.
Alternatively, you can select a “universal” mode
which means that the 788 will respond to all MMC
commands received over the system.
1 With the transport stopped, press the MENU
key.
2 Use the dial to scroll down to the SYNC/
MIDI menu and press ENTER .
3 Use the dial to scroll down to the CONTROL
menu item and press ENTER .
4 There are two tabs on this screen. Use the Ó
key to ensure that the
MMC tab is visible.
5 Use the § and ¶ keys to highlight the
DEVICE ID menu item.
6 Use the dial to make the setting: either ALL
or a value from 1 through 127 .
Note that some devices may start counting
from 0 and go up to 126 as the highest individ-
ual ID that can be set. With these units, a set-
ting of 127 corresponds to the ALL setting.
OFF All MMC commands to the 788 will be ignored.
The 788 does not transmit any MMC
commands.
MASTER All MMC commands to the 788 will be ignored.
The 788 transmits MMC commands.
SLAVE MMC commands to the 788 will be recognized.
The 788 does not transmit any MMC com-
mands.