Move -> paste, Move -> insert, Move -> paste move -> insert – Tascam 788 User Manual
Page 67: 7 – track editing–move -> paste, 67 move -> paste
7 – Track editing–MOVE -> PASTE
TASCAM 788 Digital PortaStudio
67
MOVE -> PASTE
This function takes the section of a track or tracks
marked by the IN and OUT points, and moves it to
the chosen track or tracks, starting at the TO point.
After the operation, the selected section of the source
between the IN and OUT points is replaced by
silence.
This operation overwrites anything which is already
recorded at the destination. The destination is there-
fore the same length as it was before the operation.
You can change the following values:
Src. Trk
This sets the source track or tracks
from which the section is taken. Choose
1
,through
8
to select an individual track. Choose
1/2
,
3/
4
,
5/6
or
7/8
to select a pair of tracks. Choose
1-8
to select all active tracks.
Dst. Trk
This sets the destination track or
tracks to which the selected section is moved. What
you can select here depends on what you have
selected for the source track. If you have selected a
single track, you can select tracks
1
through
8
here.
If you have selected a pair of tracks (for instance,
1/2
), you can only select track pairs here. If you
have selected all active tracks (
1-8
), then this is the
only option available to you here.
Press
YES
to perform the operation or
NO
to leave
this screen.
TIP
You can also use the SHIFT + INSERT key combination
to enter this function easily.
MOVE -> INSERT
This function takes the section of a track or tracks
marked by the IN and OUT points, and moves it to
the chosen track or tracks, inserting it as new mate-
rial, starting at the TO point.
After the operation, the selected section of the source
between the IN and OUT points is replaced by
silence.
The insert operation adds the selected section as new
material to the destination. Nothing is overwritten on
the destination, as any material following the TO
point is moved to the end of the newly-inserted
section. The destination is therefore longer than it
was before the operation.
You can change the following values:
Src. Trk
This sets the source track or tracks
from which the section is taken. Choose
1
,through
8
to select an individual track. Choose
1/2
,
3/
4
,
5/6
or
7/8
to select a pair of tracks. Choose
1-8
to select all active tracks.
Dst. Trk
This sets the destination track or
tracks into which the selected section is inserted.
What you can select here depends on what you have
selected for the source track. If you have selected a
single track, you can select tracks
1
through
8
here.
If you have selected a pair of tracks (for instance,
1/2
), you can only select track pairs here. If you
have selected all active tracks (
1-8
), then this is the
only option available to you here.
Press
YES
to perform the operation or
NO
to leave
this screen.
OUT
IN
TO
OUT
IN
TO
OUT
IN
TO
OUT
IN
TO