Tascam 788 - Manual (Page 92)

10 – Routing and scene libraries–Scene libraries
92
TASCAM 788 Digital PortaStudio
Loading routing settings from the library
You can load previously stored routing settings from
the library while playback is stopped, or while play-
ing back or recording.
NOTE
Take care when changing routing settings via MIDI control
while playing back or recording, as major changes to the
routing settings may “open up” some channels and close
others, giving unexpected results, which could result in a
spoiled recording or even damage to monitoring equipment
and your ears.
To load routing settings from a stored library entry:
1 Press the QUICK SETUP key.
2 Use the dial to scroll down to the ROUTING
LIB. entry in the list, and press ENTER :
3 Use the dial to scroll to the entry from where
you want to load the new routing settings.
4 Press ENTER . The settings are loaded and the
display returns to the assign map screen (see
“Viewing assignments” on page 37), where you
can view the effects of the load.
Scene libraries
The 788 also allows you to load and store up to ten
mixer scenes in a library for each song. These scenes
are stored automatically when the song is saved.
The 788 stores the following mixer settings as part of
a scene:
• Input assignment (including virtual track
assignment)
• EQ settings
• Effector settings and assignment
• Effect and aux send levels
• Pan
• Digital pad/gain
• Track cue mixer settings (level and pan)
• Fader settings (including the
STEREO fader)
• Sub-mixer settings
Since routing is included as part of a mixer scene,
you do not need to store routing assignments sepa-
rately from scenes unless you need to use the routing
assignments in other songs.
NOTE
Monitor settings (selection and level), and TRIM control
settings, are not stored as part of a scene.
Saving a scene to the library
You can save to the scene library while playback is
stopped, or while playing back or recording.
To store the current scene settings to a library entry:
1 Press the QUICK SETUP key.
2 Use the dial to scroll down to the SCENE
LIB. entry in the list, and press ENTER :
3 There are two tabs on the top of this display:
the
READ tab allows you to read scenes from
the library, and the SAVE tab allows you to
store the current scene to the library. If the
SAVE tab is not highlighted, press the Á key
to highlight it.
4 Use the dial to scroll to the entry where you
want to store the current settings.
TIP
You can give a title to the highlighted entry at this point, fol-
lowing the instructions in “Entering and editing titles” on
page 26.
5 Press ENTER . The scene is saved and the dis-
play returns to the home screen.