Copy -> paste, Copy -> insert, Copy -> paste copy -> insert – Tascam 788 User Manual
Page 66: 7 – track editing–copy -> paste
7 – Track editing–COPY -> PASTE
66
TASCAM 788 Digital PortaStudio
COPY -> PASTE
This function takes the section of a track or tracks
marked by the IN and OUT points, copies it, and
places it at the TO point on the chosen track or
tracks.
The original source is left unchanged.
The copy operation overwrites anything which is
already recorded at the destination. The destination is
the same length as it was before the operation.
You can copy the section more than once in one oper-
ation.
You can change the following values:
Src.Trk
This sets the source track or tracks
from which the section is copied. Choose
1
,through
8
to select an individual track. Choose
1/2
,
3/
4
,
5/6
or
7/8
to select a pair of tracks. Choose
1-8
to select all active tracks.
Dst. Trk
This sets the destination track or
tracks to which the selected section is pasted. What
you can select here depends on what you have
selected for the source track. If you have selected a
single track, you can select tracks
1
through
8
here.
If you have selected a pair of tracks (for instance,
1/2
), you can only select track pairs here. If you
have selected all active tracks (
1-8
), then this is the
only option available to you here.
Times
This is the number of times that the
selected section is pasted into the destination track or
tracks. You can set this value from
1
to
99
.
Press
YES
to perform the operation or
NO
to leave
this screen.
TIP
You can also use the SHIFT + TRIM key combination to
enter this function easily.
COPY -> INSERT
This function takes the section of a track or tracks
marked by the IN and OUT points, copies it, and
places it on the chosen track or tracks, inserting it as
new material, starting at the TO point.
The original source is left unchanged.
The insert operation adds the selected section as new
material to the destination. Nothing is overwritten on
the destination, as any existing material following the
TO point is moved to the end of the newly-inserted
section. The destination is longer than it was before
the operation.
You can copy the section more than once in one
operation.
You can change the following values:
Src. Trk
This sets the source track or tracks
from which the section is copied. Choose
1
,through
8
to select an individual track. Choose
1/2
,
3/
4
,
5/6
or
7/8
to select a pair of tracks. Choose
1-8
to select all active tracks.
Dst. Trk
This sets the destination track or
tracks into which the selected section is inserted.
What you can select here depends on what you have
selected for the source track. If you have selected a
single track, you can select tracks
1
through
8
here.
If you have selected a pair of tracks (for instance,
1/2
), you can only select track pairs here. If you
have selected all active tracks (
1-8
), then this is the
only option available to you here.
Times
This is the number of times that the
selected section is inserted (end-to-end) in the desti-
nation track or tracks. You can set this value from
1
to
99
.
Press
YES
to perform the operation or
NO
to leave
this screen.
OUT
IN
TO
OUT
IN
TO
OUT
IN
TO
OUT
IN
TO