Tascam 788 - Manual (Page 2)

2
TASCAM 788 Digital Portastudio
Important Safety Precautions
IMPORTANT (for U.K. Customers)
DO NOT cut off the mains plug from this equipment.
If the plug fitted is not suitable for the power points in your home or
the cable is too short to reach a power point, then obtain an appro-
priate safety approved extension lead or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and dispose
of the plug immediately, to avoid a possible shock hazard by inad-
vertent connection to the mains supply.
If this product is not provided with a mains plug, or one has to be
fitted, then follow the instructions given below:
IMPORTANT: DO NOT make any connection to the larger termi-
nal which is marked with the letter E or by the safety earth symbol
ç
or coloured GREEN or GREEN-and-YELLOW.
The wires in the mains lead on this product are coloured in accord-
ance with the following code:
BLUE : NEUTRAL
BROWN : LIVE
As these colours may not correspond with the coloured markings
identifying the terminals in your plug proceed as follows:
The wire which is coloured BLUE must be connected to the terminal
which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the ter-
minal which is marked with the letter L or coloured RED.
When replacing the fuse only a correctly rated approved type should
be used and be sure to re-fit the fuse cover.
IF IN DOUBT — CONSULT A COMPETENT ELECTRICIAN.
TO THE USER
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment gen-
erates, uses, and can radiate radio frequency
e n e r g y a n d , i f n o t i n s t a l l e d a n d u s e d i n
accordance with the instruction manual, may
cause harmful interference to radio comm-
unications. However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
w h i c h c a n b e d e te r m i n e d b y t u rn i n g t he
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures.
a)Reorient or relocate the receiving antenna.
b)Increase the separation between the
equipment and receiver.
c)Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
d)Consult the dealer or an experienced radio/
TV technician for help.
CAUTION
Changes or modifications to this equipment not
expressly approved by TEAC CORPORATION
for compliance could void the user’s authority to
operate this equipment.
For U.S.A