TANDBERG High Definition Professional Recevier/Decoder TT1280 - Manual (Page 135)

Menus
Reference Guide: TT128x High Definition Professional Receiver/Decoder Page C-19
ST.RE.E10141.5
C.9 System Menu (Menu 7)
C.9.1 Setup Menu
The Setup submenu allows the user to edit the operating mode, LCD
contrast, serial remote protocol, IP address, subnet mask, service hunt
mode, and the customisation key.
Table C.30: Setup Menu
Display Title: Setup Description
Date: XX/XX/XXXX
Time: YY:YY:YY XX/XX/XXXX is the system date from the TDT
YY:YY:YY is the system time from the TDT
Operating Mode
XXXXXXXXXXXXX XXXXXXXXXXXXX is editable:
FRONT PANEL
SERIAL REMOTE (not supported in software version 1.0.0)
NETWORK (SNMP)
LCD Contrast XXXXXX XXXXXX is editable in the range:
LOW
MEDIUM
HIGH
Serial Remote Protocol
XXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXXXX is editable:
RS-232 TTV, RS-232 ALTEIA AT ADDR YYY, RS-485 ALTEIA AT ADDR YYY
where YYY is IRD address from 000 to 999.
IP Address
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX is the editable IP address
Subnet Mask
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX is the editable subnet mask
Gateway Address
XXX.XXX.XXX.XXX XXX.XXX.XXX.XXX is the editable Gateway address
Syslog Address
XXX.XXX.XXX XXX.XXX.XXX is the editable Syslog address.
Restore System Defaults Restores system defaults.
Service Hunt Mode
XXXXXXXX XXXXXXXX is the editable parameter for setting automatic service selection
(ENABLED, DISABLED)
SI Mode
XXX XXX is the editable parameter for SI detection (AUTO, ATSC, DVB)
Customisation Key
XXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXXXXX is the editable parameter for entering
customisation keys